
Sika Setting Sand: Buff 20kg Patio Grout

Pay in 3 interest-free payments on purchases from £30 - £2,000 with PayPal. Learn More
Sika Setting Sand: Buff | Patio Grout
Sika Setting Sand is a high-quality jointing compound/Patio Grout that provides a durable and long-lasting finish for your paving/patio projects. Its unique formulation is specially designed to harden quickly, allowing for faster completion of your projects. This product is suitable for use with a variety of natural stone, concrete, and porcelain paving, and can be used both indoors and outdoors.
Sika Setting Sand is an easy to use, moisture curing jointing material for all types of paving having joint width of 2-5 mm and over. Setting Sand is suitable for all types of block paving and can be used in areas subject to light vehicular traffic.
Features & Benefits:
- Sets hard, wont crack or wash out.
- Resists weeds and insects.
- Suitable for all types of block paving.
- Weathers naturally in line with the paving.
Usage
- Footpaths.
- Outdoor patio areas.
- Indoor stone floor areas.
- Pedestrian areas.
- Driveways.
Shelf Life
12 months from date of manufacture when stored in unopened containers in accordance with manufacturer’s instructions.
How to Apply Sika Setting Sand Patio Grout
It is recommended to carry out a small trial in an inconspicuous area or on off-cuts of paving prior to application.
Due to the nature of the product, some settling of the jointing material will occur in transit and storage. It is therefore essential to re-mix the dry material prior to use, to enable the jointing compound to cure consistently. Discard any small lumps and do not add extra sand to the dry material.
- Use in small, manageable amounts and avoid spreading over a large area. Sweep the material into the joints, making sure each joint is completely filled. (If rain is expected prior to hardening, the surface must be protected to ensure a smooth finish)
- Sweep up any excess material immediately as it can be difficult to remove once set.
- Thoroughly soak the joints with a hose pipe set to spray or a watering can fitted with a rose. Do not use a pressure washer. Ensure joints are all fully saturated. Rinse excess material from the surface.
- The finished surface is safe to walk upon immediately after activation, but ideally should be left to dry.
Drying will normally take 1 – 2 days although the time required for full cure is dependent upon temperature. At lower temperatures, the cure time will be slower. It will take up to 28 days to achieve full cure.
Datasheet:
Technical Datasheet